新闻资讯

环氧地板漆施工前需做的准备包括哪些?

环氧地板漆重新建造后会发生什么?首先,在环氧地坪施工开始时必须保持地面干燥,不要继续在不干的地面上工作。当地板涂料被涂上时,用干净的布清洁表面,以除去表面的湿气。选择配套腻子和配套底漆,不要用虫胶漆底漆和酸固化底漆。在环氧地板漆膜开始膨胀,膨胀后被击倒,选择引物完成底漆二层,然后重新粉刷油漆。其实有很多解决办法,但最基本的保养就是最好的地板方式。环氧地板漆在低温条件下会发生什么?在低温下,环氧地板漆的粘度增加了一倍。

What happens when epoxy floor paint is re built? First of all, it is necessary to keep the ground dry at the beginning of the epoxy floor construction and not continue to work on the non-working ground. When floor coating is applied, clean the surface with clean cloth to remove moisture from the surface. Choose matching putty and matching primer, do not use shellac primer and acid curing primer. When the epoxy floor paint film begins to expand and is knocked down after expansion, the primer is selected to finish the second layer of primer, and then the paint is repainted. In fact, there are many solutions, but the most basic maintenance is the best floor mode. What happens to epoxy floor paint at low temperatures? At low temperatures, the viscosity of epoxy floor paint doubled. 在低温条件下会使自流平不能自然平整地面,XX环氧地板漆由于粘度太高,而人在找平时会出现划痕,严重影响使用效果。

Under low temperature conditions, self-leveling can not smooth the floor naturally. XX epoxy floor paint has high viscosity, and people will scratch in peacetime, which seriously affects the use effect.

由于在固化反应缓慢,或完全不能治愈,涂抹效果会有一定程度的降低,温度越低效果较差,可以脱离地面,所以低温施工是地板上的一个重要组成部分,它是更好地在建设5度以上,虽然外观可以做出一些补救措施,但会影响地板的使用寿命,所以最好不要在低温下进行施工。

Because the curing reaction is slow or can not be cured at all, the application effect will be reduced to a certain extent, the lower the temperature, the worse the effect, can be separated from the ground, so low-temperature construction is an important part of the floor, it is better in the construction of more than 5 degrees, although the appearance can make some remedial measures, but it will affect. The service life of flooring is best, so it is best not to carry out construction at low temperatures.

环氧地坪的特点和施工流程

Characteristics and construction process of epoxy floor

环氧地坪公司擅长环氧环氧地坪,各类环氧地坪项目全案设计及实施。

Floor company specializes in epoxy floor, all kinds of epoxy floor project design and implementation of the whole case.

环氧地坪特点:

Epoxy floor features:

1、防潮,防尘;

1, moisture-proof and dustproof;

2、整体无缝,易清洁;

2, the whole seamless, easy to clean;

3、抗冲击,高荷载;

3, impact resistance and high load;

4、维护方便,成本经济;

4, maintenance is convenient, cost economy;

5、可做防滑或哑光效果。厚度从0.3-0.5mm起,通常为1mm,2mm,3mm,厚度主要取决于素地情况及承载量,越厚整体性能越好。

5, can do anti slip or matte effect. Thickness is from 0.3 to 0.5 mm, usually 1 mm, 2 mm, 3 mm. Thickness mainly depends on the condition of plain land and load capacity. The thicker the overall performance is, the better.

环氧地坪施工流程:

Epoxy floor construction process:

①素地处理:依据素地状况进行打磨、除尘、修补;

(1) plain land treatment: grinding, dedusting and repairing according to the condition of prime soil.

②环氧底漆:采用渗透性及附着力特强环氧底漆批涂一遍,增强表面附着力;

(2) Epoxy primers: epoxy primers with strong penetration and adhesion are batched once to enhance surface adhesion;

③环氧砂浆:底涂固化后将调配好的石英砂材料用镘刀均匀批涂;

Third, epoxy mortar: after the bottom coating is solidified, the well made quartz sand material is uniformly smear coated with a trowel.

④环氧中涂:将环氧树脂调配好后,用镘刀将其均匀批涂;

(4) epoxy coating: evenly mix epoxy resin with a trowel.

⑤环氧腻子:依据实际需要,要求达到平整无孔洞,无批刀印以及打磨印为准;

Epoxy putty: According to actual needs, it is required to be flat without holes, no batch of knife prints and grinding prints.

⑥环氧面漆:将调配好的面涂漆用滚筒均匀的涂层一遍,完工后整体地面光亮洁净、颜色均一,无空鼓;

Epoxy topcoat: The prepared topcoat is coated once with a uniform roller. After completion, the whole ground is bright and clean, uniform in color and no empty drum.

⑦施工完成:24小时后方可上人,72小时后可重压。

The construction is completed: 24 hours later, the upper body can be weighed after 72 hours.

相关文章